FAA Halts New Router Installs and Switches Off Those Already In
Technicians traced Friday's nationwide ground stop to one newly installed router in Arkansas, the Associated Press reports. The FAA says it has not found the root cause.
The Federal Aviation Administration has stopped installing the new network routers linked to Friday's nationwide ground stop and turned off the ones already in service, an agency spokesperson told ABC News on Tuesday. The FAA said it "has not yet determined the root cause of Friday's issue."
Technicians traced the disruption to a single router recently installed in El Dorado, Arkansas, the Associated Press reports. The FAA has said the network was flooded with "excessive data" at "a rate of 1,000 connection attempts every 4 to 5 seconds," which overwhelmed older routers and disrupted aircraft communications and radar feeds. Seventeen of the 22 regional centers that handle high-altitude traffic were affected, according to the AP.
For now the agency is relying on Cisco routers that have been in place for about 25 years, the AP reports. The new routers, made by Juniper and installed by contractor L3Harris, are being tested in a lab at L3Harris headquarters. Senate Commerce Committee Democrats believe about 400 of more than 3,600 planned routers had been installed.
In a letter to Transportation Secretary Sean Duffy on Tuesday, Senate Democrats asked that the replacement program stay paused until "the root cause of the failure has been identified," writing that "identifying the device that failed does not establish why it failed." The administration on Tuesday put its request for air traffic control modernization at $50.1 billion, the AP reports. Congress approved $12.5 billion for modernization last year.
Sources